Laser Module

Can engrave:

Wood, plastic, paper, leather

Can cut:

Paper, thin leather, thin wood plate

Cannot engrave:

Metal, glass, stone, etc

Note: the adapter only have US, EU standard. it is bonus for free. if it is not suitable, pls find a suitable one in your supermarket.

Specification

1. when you adjust the beam diameter at 20-200mm, the beam is 0.3-0.5mm. it can be used as cutting, engraving or marking on wood, paper, leather and plastic.

2. when you adjust the laser beam for fatter, it can be used as stage lighting.

3. when you use the pwm, the pulse output is 1.25w, it is suitable for engraving, marking or cutting.

4. when you use it as cw output, it is 1-1.05w output.

5. we had updated the fan cooling system on the housing which helps the laser get better heatsink effect and protect the laser longer duty cycle.

6. it is very bright so that when we use it on stage lighting, it get very good effect

Stage Lighting 532nm 50mw-80mw Green Laser Diode Module with Fan Adapter 12VDC

Features

1. suitable for escape room, haunted house, stage lighting, bird scaring and similar circumstance

2. duty cycle: 6-8hrs

3. fan cooling system

3380 808nm 0.8W IR infrared Dot Laser Module

3380 980nm 0.8W IR Infrared Dot Laser Module with TTL

Usage:

1. Stage lighting shows

2. Scare birds and animals

3. Laser curtain

4. Laser harp

5. Laser wine bar base

6. Escape room

7. Amusement park

8. Pleasure groud and squares

9. Holiday lighting effect

10. PM 2.5 PM 10 dust/humid testing

Usage:

1. Stage lighting shows

2. Scare birds and animals

3. Laser curtain

4. Laser harp

5. Laser wine bar base

6. Escape room

7. Amusement park

8. Pleasure groud and squares

9. Holiday lighting effect

10. PM 2.5 PM 10 dust/humid testing

11. Spinning machine location

Features

1. Stage Lighting

2. PM2.5 PM10 testing

Instructions for use:

1 Connect the power plug before turning on the switch. Power is applied for 10 minutes into a stable state. Switching power supply interval should be greater than 5 seconds, or easily damaged lasers.

2 power panels should be placed on an insulator or overhead when using, otherwise it will bake a bad laser power. At the same time, and not let the laser power cables suffered at great force, so as to avoid the laser internal wiring circuit.

3 This laser is normally used on stage lighting shows, so that the heatsink by itself is not suitable for 7/24 working.

4 Please note that the use of dust, the dust can not be used in place much, if not a long time in the laser light hole stickers affixed dust. 5 This laser has a switch to adjust from TTL to analog.